How to Buy Replacement Glass Shades That Actually Fit
One shade on a five arm chandelier cracks when a door slams, and suddenly a fixture that cost 400 pounds is unusable.

One shade on a five arm chandelier cracks when a door slams, and suddenly a fixture that cost 400 pounds is unusable. You measure the broken one, order something that looks identical, and it arrives 4 millimetres too wide to seat in the ring. Now you own two useless shades.
Replacement glass shades are one of the few lighting purchases where the look of the thing matters less than a single measurement. I have sat on my grandfather's workshop floor sorting boxes of orphaned shades by neck size, and the ones nobody could ever use were never the ugly ones. They were the ones where the fitter was an odd size.
The fitter is the only part that has to match
A glass shade attaches to a fixture through its fitter, the small opening or collar at the narrow end. Everything else, the shape, the height, the frosting, the flare of the bell, is a matter of taste. The fitter is a hard constraint.
There are four common systems and they are not interchangeable.
Lip fitter. The glass has a thickened rim that drops into a metal ring on the arm and is held by gravity or by a threaded collar screwed up from below. This is what most chandelier and wall sconce shades use.
Neckless. No collar at all. A straight hole in the top of the glass sits over a socket holder and three small thumbscrews pinch the outside of the glass. Common on modern pendants and on bathroom bars.
UNO fitter. The shade has an internal thread or a flange that screws directly onto the lamp socket, used mainly on bridge lamps and some wall lights rather than chandeliers.
Clip on. A sprung wire cage that grips the bulb itself. Fine for small candle bulbs and hopeless for anything heavy.
Measure the fitter with a vernier caliper if you have one, or with a steel rule across the widest point of the lip. Do it in two directions, because old pressed glass is often half a millimetre out of round, and order to the smaller reading.
Standard sizes, and the ones that will cause trouble
Most of what you can buy today lands on a short list of sizes. If your measurement matches one of them, replacement is easy and cheap. If it falls between them, read the next section before you spend anything.
| Fitter size | Metric | Usually found on |
|---|---|---|
| 1 5/8 inch lip | 41 mm | Small chandelier candle shades, older wall lights |
| 2 1/4 inch lip | 57 mm | The most common size by a wide margin, sconces and chandeliers |
| 3 1/4 inch lip | 83 mm | Kitchen pendants, schoolhouse globes |
| 4 inch lip | 102 mm | Larger pendants and some flush mounts |
| 6 inch lip | 152 mm | Big bowl shades on antique fixtures |
| 1 5/8 inch neckless | 41 mm | Contemporary pendants with thumbscrews |
A 2 1/4 inch shade costs somewhere between 6 and 25 pounds depending on the glass, and a chandelier set of five is rarely more than 90 pounds. A 6 inch bowl for a 1920s fixture is a different market, often 60 to 150 pounds for a single piece, and sometimes only available secondhand.
Why matching by brand and model is the wrong first move
The advice you will get in most forums is to find the maker's label, look up the model number and order the exact part. It sounds obviously right. In my experience it works maybe a third of the time, and chasing it costs weeks.
The reason is that very few lighting brands make their own glass. They buy pressed or blown shades from a handful of suppliers, and those contracts change. Two chandeliers sold under the same model number three years apart can carry shades from different factories with slightly different lips. The brand parts counter will cheerfully confirm the model and send you a shade that does not seat.
So measure first and treat the model number as a tiebreaker rather than the search term. Once you know you need a 57 millimetre lip fitter, 7 inches tall, in opal etched glass, you can buy from anybody and you will be able to tell from a product listing whether it will fit.
The honest exception is a high end fixture bought in the last two or three years, where the maker still holds stock of the matching glass. Then the brand route is both easier and better, because the colour of the opal will match the four shades you are keeping. I would ring them before measuring in that one case.
Getting glass that looks like the shades you are keeping
Fit is solvable. Match is the part people underestimate, because you are not replacing a shade, you are replacing one of six and the other five have aged.
Clear glass is the safest to mix. It yellows very little and a new piece sits next to a forty year old one without drawing the eye. Opal and alabaster glass are the worst, because the white picks up a warm cast from decades of heat and dust, and a brand new one reads as blue by comparison. Frosted and acid etched glass sits in between.
Three things that help when you cannot find an exact match. Position the new shade on the arm that faces the wall, or the one furthest from where people sit. Switch to a lower wattage LED in that one socket, since 2700 kelvin at slightly lower output disguises a brightness mismatch better than a perfect colour match disguises a size mismatch. Or replace all of them, which sounds extravagant until you compare the cost of six 8 pound shades against the hours you will spend hunting one discontinued piece.
If the shades are gone but the crystals are also chipped, do the two jobs together. Our guide to replacing chandelier crystals so they match covers the pin and bead sizes that cause the same kind of near miss.
Buying secondhand and from salvage
Salvage yards, auction sites and architectural reclaim dealers are where the odd sizes live. A few rules I have learned the slow way.
- Ask for the lip measurement in millimetres, not the shade name. Sellers describe glass by shape. A seller who will go and measure the fitter is a seller worth buying from.
- Ask about the rim, not just the body. Chips on the lip are the ones that matter, because that is the surface carrying the weight. A chip on the bottom edge of a bell shade is cosmetic and worth a discount.
- Check for heat crazing. Hold the glass to a window and look for a fine web of lines near the fitter. That glass has cooked and it will crack again within a year.
- Buy spares. If you find a matching set of six and only need one, buy all six. Nobody has ever regretted having two spare shades in a cupboard.
Telling genuine old glass from a modern reproduction is a related skill, and some of the same tests apply, as our piece on real crystal and glass on a used chandelier sets out. There is more on the same theme across the buying lighting section.
Frequently asked questions
Can a glass shade be a slightly different size and still work?
Smaller is sometimes workable with a felt or silicone gasket to take up 1 or 2 millimetres. Larger never is. A lip that will not drop fully into the ring leaves the shade sitting proud and it will rattle loose.
Are replacement shades sold as singles?
Yes, most are, though some chandelier shades are only offered in sets of five or six. Sellers who list singles usually charge a few pounds more per piece than the set price.
Will an LED bulb stop shades cracking?
It helps a great deal. Most cracking near the fitter comes from heat cycling, and a 5 watt LED runs far cooler than a 40 watt incandescent candle bulb. It does not help with door slams.
How do I measure a neckless shade?
Measure the diameter of the hole at the top of the glass, not the outside of the collar. The thumbscrews grip the outer surface, so the hole diameter and the glass thickness both need to be close to the original.
More in Buying Lighting
Buying Lighting
What Is CRI in Lighting and Why It Matters When Buying Bulbs
You fit new LED bulbs, flick the switch, and the room looks oddly flat.
Buying Lighting
How to Choose Wall Sconces and Where to Mount Them
Wall sconces look simple in a showroom, then go up at home and suddenly glare into your eyes, stick out into a narrow hallway...
Buying Lighting
How to Choose a Floor Lamp for Reading Without Eye Strain
You sit down with a book in the evening, and within twenty minutes your eyes ache, the page has a shadow across it, or the bulb...